Previous
Ultimaker 2 nozzle 0.40mm Stainless Steel

Ultimaker 2 Nozzle – Stainless Steel 0.50mm

 10,89 incl. tax
Next

Heat cartridge for Ultimaker 2 – 35w

 30,25 incl. tax
Ultimaker 2 Heater Cartridge 35w

Ultimaker 2 Nozzle – ‘JET’ RSB 0.15mm

 29,04 incl. tax

This 0.15mm brass nozzle is ultra fine, use it for very small and detailed prints. Reserved for confirmed experts only!

This nozzle is compatible with M6 Threads, you can put it on the Ultimaker Original (the fan shroud must be modified) or any of the Ultimaker family that has the Olsson Block mounted.

Out of stock

SKU: IdeaTo3d_862 Category: Tags: , ,

Description

Ultimaker 2 Nozzle – ‘JET’ RSB 0.15mm

The brass Jet nozzles have a special tip angle and shoulder width, they also have a special internal geometry with an angle less steep down to the nozzle hole. A special treatment applied inside also makes them slip more. You can print 3°c to 5°c lower because of this treatment, this is also usefull for oozing and drips.

With these special nozzles you can print faster, the plastic will flow much more easier than in classic nozzles. You can also clean them very efficiently with cold pulls (or atomic pulls). The geometry of the inside makes it easier to get rid of plastic so changing colors or filament type is done faster and safer.

 

Customers' review

5 stars 0 0 %
4 stars 0 0 %
3 stars 0 0 %
2 stars 0 0 %
1 star 0 0 %

Reviews

There are no reviews yet.

Be the first to review “Ultimaker 2 Nozzle – ‘JET’ RSB 0.15mm”

Shopping cart

0
image/svg+xml

No products in the cart.

Continue Shopping