Précédent
Image du produit précédent

Ultimaker 2+ capot et porte

 372,08 392,25 TTC
Suivant

Kit de maintenance Ultimaker 3 #9523

 228,69 TTC
Image du produit suivant

Feuilles d’adhésion Ultimaker S5 #210702

 36,24 TTC

Les feuilles d’adhésion Ultimaker sont la solution idéale pour l’adhésion des filaments qui ont une accroche difficile sur le plateau (par exemple le PP).

Pour la Ultimaker S5

UGS : IdeaTo3d_8461 Catégorie :

Description

Thanks to the Adhesion sheets of Ultimaker, your prints will adhere to the build plate better, producing consistent high-quality results.

Underneath is a guideline on how to apply these Adhesion sheets correctly, to prevent air bubbles and to ensure a smoother, flatter surface.

Applying the adhesion sheet
To apply the adhesion sheet to your glass plate, you have to follow these steps.

1. Remove the build plate from your printer by opening the clamps at the front of the plate. Then gently slide the plate out of the printer.
2. Wet the glass plate with some water and a small amount of soap. Make sure that the warning sticker is facing upwards.
3. Remove the back liner from your adhesion sheet.
4. Slowly start applying the adhesion sheet to your print plate. Start in the middle, then lower the sheet onto the glass plate.
5. Sweep the water outwards from underneath the sheet, starting at the center. This to reduce the number of air bubbles. Be careful not to tear the sheet.
Note: Air bubbles under the sheet can distort the first printed layer. If the bubbles can’t be removed, consider popping them with a needle.
6. Once the sheet is applied, and is bubble-free and dry, place the glass plate back in the printer and secure with the build plate clamps. Heat the build plate to 100 ºC so the remaining water under the sheet can evaporate.

Removing the adhesion sheet
The adhesion sheet can be used multiple times, but once it has been damaged, you may need to replace it. To remove the adhesion sheet from the glass plate, take the following steps.

1. Remove the glass plate from the Ultimaker.
2. Take one of the corners of the adhesion sheet and peel it approximately 3 cm from the glass plate surface. Hold the glass plate under a tap and let the water run under the adhesion sheet while slowly pulling the sheet off at a 90-degree angle. The sheet shouldn’t leave a sticky residue.
3. Continue switching to a different corner of the adhesion sheet in order to pull it off completely.
4. Remove any glue residue from the glass plate with a sponge and soap.

Customers' review

5 stars 0 0 %
4 stars 0 0 %
3 stars 0 0 %
2 stars 0 0 %
1 star 0 0 %

Reviews

There are no reviews yet.

Be the first to review “Feuilles d’adhésion Ultimaker S5 #210702”

Informations complémentaires

Poids 0,5 kg

Panier d’achat

1

Sous-total :  907,50 (TTC)

Voir le panierCommander